|
Matte
red vehicle wrap vinyl comes in a 60" wide roll and is sold by the
foot. Price starts at $12.99 for
the 1st linear foot. Each quantity ordered is equal to 1 linear foot,
or 12 inches. For example, to order a 60" wide x 72" long
sheet, you would select quantity of "6". You'll receive
one continuous sheet when you order more than 1 linear foot.
Matte
red vehicle wrap vinyl can be applied to any hard smooth surface such
as such as front hood, rear trunk, spoiler, lips, side pillar bars, rims,
side mirrors, door handles, windshield, interior trim, cell phones, laptop,
speakers, etc.
Notes:
Install in a clean area, away from dust and wind. Application surface
should be cleaned with soap and water or other cleaning agents. Cleaning
agents must NOT contain ammonia (like Windex) as these will dissolve
the adhesive. On complex curves and edges, apply heat for better adhesion
and conformity to curved surface. 3M
Primer 94 is recommended for application involving sharp
edges or extreme curves.
|
- Permanent
acrylic pressure-sensitive adhesive
- Air
Egress Technology
- Lay-flat,
bubble free installation
- Dry
Application. No need for messy soap and water
- Can
be re-lifted, repositioned and stretched
- Stretchable
with heat
- Conform
to contours and bend easily
- High
temperature & water resistant
- Install
Temp: 60F to 80F (16C to 26C)
- End
Use Temp: -4F to 206F (-15C to 97C)
- Can
be cleaned with soap and water
- Stands
up against water, dirt, grease, salt, mild acids and oil.
- Long
life with excellent UV durability: 3 yr outdoor/8 yr indoor
- Design
for auto wrapping, 5 mil (.005" thick film)
|
|